Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Pinehurst, TX
Gate access control work in Pinehurst is dominated by automatic driveway entry gates on acreage properties, where a keypad or intercom failure means a 300-foot walk to the road. The shrink-swell clay soil under Montgomery County shifts posts seasonally, which throws off the alignment that the keypads, photo-eyes and limit switches depend on. If your gate stopped responding or opened halfway and reversed, call (346) 296-3138 and we’ll send a technician who understands Pinehurst’s ground conditions.
Why Pinehurst Homes Are Different
Pinehurst sits on some of the most movement-prone clay in Montgomery County. The soil expands when wet and contracts hard during dry stretches, so gate posts heave and settle through the year. That constant motion changes the position of every component bolted to the post: hinges bind, operators work against the gate instead of with it, and the photo-eye beam drifts out of line by an inch or more. A repair that would be routine on stable ground becomes a recurring job here unless the root cause is addressed. Most properties are ranch-style homes on one to several acres, and many hold ag exemptions or keep hobby livestock. The gates are heavy steel pipe or ornamental iron, not lightweight aluminum, so every motor and hinge carries real weight. Driveways are often set back 200 to 400 feet from the road, and without utility power at the gate, solar operators and battery banks are the standard setup. Humidity and heavy rain from the San Jacinto watershed accelerate surface rust on raw steel, and the flood-drought cycle works the post footings hard. All of this means Pinehurst repairs need a technician who checks the soil, the post, and the power source, not just the motor.
Our Main Pinehurst Services
These are the three services Pinehurst homeowners call about most, each with its own dedicated page for this area.
Gate Repair in Pinehurst
Gate repair here usually starts with a misaligned operator or a hinge that has seized after a wet season pushed the post several degrees out of plumb. We repair swing-arm and slide-gate operators, replace worn hinges, and reset photo-eyes so the gate stops safely instead of reversing mid-travel. Every repair is documented with photos and a written record of what was adjusted. See the full scope at Gate Repair in Pinehurst.
Gate Installation in Pinehurst
A new gate on a Pinehurst acreage property has to be engineered for clay movement, not just welded together. We set posts deeper than typical subdivision depth, use heavy-duty hinges, and match the operator to the gate’s actual weight and the driveway’s power situation, which on many Pinehurst lots means solar. Every installation includes a written scope and price before work begins. Learn more at Gate Installation in Pinehurst.
Gate Motor & Opener in Pinehurst
When an operator fails on a 400-foot setback, the problem is almost always made worse by the clay shifting the gate out of alignment and forcing the motor to work against binding steel. We service LiftMaster, FAAC, Elite, and Mighty Mule units on Pinehurst properties, diagnosing the motor and its power supply together. See what’s covered at Gate Motor & Opener in Pinehurst.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Pinehurst
Gate access control in Pinehurst means keeping an automatic gate working on a property where the gate is the only line between the road and the house. The keypad bolted to a steel post that has shifted six degrees in the clay is going to fail, not because the keypad is bad, but because the connection points and alignment moved with the post. We service residential access systems on acreage lots throughout Pinehurst, handling everything from keypad entry to phone entry on solar-powered operators, and we document every setting change so the next service call starts from a record, not a guess. This is the same commercial-grade documentation Adrian Vance built in access-control work starting in 2014, applied to residential gates. See the full range at Gate Access Control.
Keypad Entry
Signs you need it
The keypad lights come on, but the gate doesn’t respond, or it works intermittently after rain.
What it costs in Pinehurst
Replacing a residential keypad in Pinehurst typically runs $220-$450, including the new unit and wiring check at the post.
How we do it
We test the existing keypad circuit, replace or rewire the unit, then photograph the new connections and record the code path before we leave.
Phone Entry
Signs you need it
The gate won’t open when you call the entry number, or the system rings but never releases the latch.
What it costs in Pinehurst
Phone entry repairs in Pinehurst usually land between $250 and $500, depending on whether the controller or the power supply is at fault.
How we do it
We test the relay, the phone line or cellular module, and the gate release, then replace only the component that actually failed.
What Gate Access Control Costs in Pinehurst
| Item | Typical range in Pinehurst |
|---|---|
| Keypad replacement | $220-$450 |
| Phone entry repair | $250-$500 |
| Video intercom system | $900-$1,800 |
Can you fix a keypad that got wet during a Pinehurst storm?
Yes, in most cases the keypad itself survives but the wiring behind it takes on moisture and corrodes. We test the circuit, dry and seal the connections, and replace the unit only if the board is damaged. Call (346) 296-3138 for a same-day visit.
Does my solar-powered gate need different access control equipment?
No, but the access control system has to be wired to the operator’s battery bank, not to grid power. We size every keypad and phone entry install to the solar setup already on the property. Call (346) 296-3138 for a written quote.
Gate Parts & Welding in Pinehurst
Gate parts and welding in Pinehurst is rarely a bolt-on job. The heavy steel pipe gates common on acreage lots rust, fatigue, and bend at the weld points, and the clay soil keeps working the posts until hinges snap or rails separate. We repair and rebuild gates in place, cutting out failed sections and welding in new steel, then photographing every weld and every part number so the repair record is complete. See the full scope at Gate Parts & Welding.
Hinge Replacement
Signs you need it
The gate sags toward the latch side and scrapes the ground, or the hinge pin is visibly worn flat on one side.
What it costs in Pinehurst
Hinge replacement on a heavy Pinehurst gate typically runs $180-$450 per hinge, depending on the weight and how far the post has moved.
How we do it
We lift the gate off the failed hinge, grind out the old weld, set the new hinge on a plumb plane, and photograph the finished weld.
Post Replacement
Signs you need it
The post leans more than two degrees off vertical, or the gate drags no matter how many times the hinges are adjusted.
What it costs in Pinehurst
Post replacement in Pinehurst ranges from $500 to $1,500, including digging out the old footing and setting a new post in concrete.
How we do it
We cut out the old post, dig the footing to below the clay movement zone, set the new post, and allow the concrete to cure before rehanging the gate.
Rail Repair
Signs you need it
A horizontal rail has rusted through, cracked at a weld, or separated from the vertical pickets.
What it costs in Pinehurst
Rail repair typically falls between $200 and $500, depending on the length of the run and how much of the surrounding steel needs to be cut back.
How we do it
We cut out the failed section, weld in new matched steel, grind the weld smooth, and photograph the repair before it’s painted.
What Gate Parts & Welding Costs in Pinehurst
| Item | Typical range in Pinehurst |
|---|---|
| Hinge replacement | $180-$450 per hinge |
| Post replacement | $500-$1,500 |
| Rail repair (welded) | $200-$500 |
Can you weld a rusted gate back together, or does it need replacing?
Usually we can weld it back. The common failure is rust at a joint or a crack at a weld, and both are repairable by cutting back to good steel and welding in a new section. Call (346) 296-3138 and we’ll assess it on site.
How long does a welded repair last on a Pinehurst gate?
A properly executed weld on cleaned steel lasts as long as the original joint, though the surrounding rust and the clay movement will always be the limiting factors. We photograph every weld so you have a record. Call (346) 296-3138 for a written estimate.
Brands We Service in Pinehurst
We work on LiftMaster, FAAC, Elite, and Mighty Mule operators in Pinehurst, and we stock common boards, remotes, and photo-eyes on the truck for same-day swap-outs. If we need a less common part, we typically have it within two business days. See our brands for the full list.
Pricing for Gate Repair in Pinehurst, TX
| Service | Typical range in Pinehurst |
|---|---|
| Keypad replacement | $220-$450 |
| Phone entry repair | $250-$500 |
| Video intercom system | $900-$1,800 |
| Hinge replacement | $180-$450 per hinge |
| Post replacement | $500-$1,500 |
| Rail repair (welded) | $200-$500 |
| Swing gate motor replacement | $700-$1,300 |
| Slide gate motor replacement | $800-$1,600 |
| Solar panel & battery upgrade | $600-$1,200 |
Prices in Pinehurst push higher when posts have moved badly in the clay and the gate has to be rehung before any other work makes sense. Every price above is a range, not a final number. You get a written, flat price before we start, and you approve it before any work begins.
Neighborhoods We Serve in Pinehurst
We cover the full Pinehurst area, from the acreage lots north of town to the properties along the San Jacinto corridor. Most calls are within a 30 to 45 minute response window during normal hours.
- Pinehurst acreage lots along FM 149
- Properties near the San Jacinto River
- Ranch-style subdivisions north of town
- Country homes along Farm to Market roads
Service Area - Cities Near Pinehurst
We also serve homeowners in Tomball, TX, Conroe, TX, Prairie View, TX, and Spring, TX. If you’re unsure whether we cover your property, call (346) 296-3138 and a live person will tell you.
Serving Pinehurst, TX - Our Local Coverage Area
We’re based in the Pinehurst area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Pinehurst
For emergency repairs like a gate stuck open or an operator that won’t respond, we typically reach most Pinehurst properties within 30 to 45 minutes. A live person answers the phone 24 hours a day, so you’ll know exactly when a technician is on the way. Call (346) 296-3138.
Most gate repairs and replacements on existing posts don’t require a permit in Montgomery County, but new post installation or significant electrical work may. We check the current county requirements for every job and let you know before we start. You’ll have the written scope in hand first.
Yes. A large share of the gates we service in Pinehurst run on solar, and we diagnose the battery bank, panel, and operator as one system. We stock common solar components on the truck and can usually get a misbehaving solar gate working the same day. Call (346) 296-3138 for a free estimate.
Call (346) 296-3138 for a free estimate on gate access control or gate parts and welding in Pinehurst. You’ll get a written price before any work starts, a photographed record when the job is done, and the 365-Day Done Right Promise on every repair.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Pinehurst Customers Say
"The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."They installed the opener and left me a diagram of the wiring and the limit settings. When I needed a second remote programmed I could do it myself."
- Nadine C."Good work on a long driveway gate. Arrived when they said, finished when they said."
- Sofia E.