Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Tomball, TX
Gate access control in Tomball usually means one of two things: a keypad or intercom at the driveway that stopped talking to the motor, or an aging system on a ranchette property that was never fully repaired after the February 2021 freeze. The fix is rarely just swapping a battery. Around FM 2920 and the acreage lots off Hufsmith-Kohrville Road, we’re usually chasing corroded wiring, misaligned photo-eyes, or a keypad that’s taken too many humidity cycles and given up. If your gate won’t open or the entry system is dead, call (346) 296-3138 and a live person answers, day or night.
Why Tomball Homes Are Different
Tomball’s gate work splits into two worlds. The older core near downtown has small lots, short driveways, and modest single-swing gates from the 1990s that have seen decades of Gulf Coast humidity. Then there’s the ring of ranchette and horse-property acreage along Hardin Store Road, Hufsmith-Kohrville, and the SH 249 corridor, where driveway gates are 15 to 25 years old, ornamental iron has rusted through at the hinge welds, and the real problem is usually under the post, not on top of it.
Harris County’s expansive black clay is the single biggest driver of gate failure in Tomball. It swells after heavy rain and shrinks in drought, heaving posts out of plumb until a gate that closed fine in March won’t catch the latch in August. We re-set more posts in Tomball than in any other market we serve. Add the 2021 freeze, which cracked conduit and damaged hydraulic operators across the area, and a lot of gates out here are running on partial repairs that were never completed. A call about a gate that won’t close is often a structural job wearing a motor’s symptoms.
Our Main Tomball Services
These are the two calls we get most from Tomball homeowners, and each one has its own detailed page with local pricing and answers.
Gate Repair in Tomball
When a Tomball gate won’t open, binds mid-swing, or grinds against the post, the cause is usually a combination of clay-shifted posts, corroded hinges, and a motor that’s been fighting both for years. We diagnose the full system, not just the part that made the noise. See the full breakdown at Gate Repair in Tomball.
Gate Installation in Tomball
New gate installations in Tomball have to account for the soil before the first post goes in. We size footings for expansive clay, weld or bolt the frame to spec, and set the automation so it isn’t fighting the terrain from day one. The process and pricing are on the Gate Installation in Tomball page.
Gate Motor & Opener in Tomball
From swing-arm operators on acreage driveways to slide-gate motors on HOA entrances, Tomball’s humidity and power-surge history stress motors hard. We service nine major brands, including Ghost Controls, DoorKing, and Elite, so we repair what’s already there rather than pushing a replacement. Details are at Gate Motor & Opener in Tomball.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Tomball
Gate access control in Tomball means the systems that decide who gets in: keypads, card readers, phone entry, and video intercoms. Most of the ranchette properties off Hufsmith-Kohrville Road run a single keypad or intercom wired back to a control board, and when the gate stops responding, the board is usually fine. The problem is corrosion in the conduit, a keypad that’s absorbed years of humidity, or a freeze-damaged wire splice someone patched in 2021 and forgot. Our full Gate Access Control service covers the hardware, the wiring, and the programming so the gate answers every time.
Keypad Entry
Signs you need it
The keypad works intermittently after rain, ignores certain codes, or the buttons stick and double-type.
What it costs in Tomball
A new keypad with reprogramming typically runs $180 to $420 installed, depending on whether the wiring and conduit are reusable.
How we do it
We test voltage at the keypad, inspect the wire run for corrosion, replace the unit, reprogram the codes, and photograph the finished work.
Video Intercom
Signs you need it
The visitor station powers up but won’t call the house, or the video is black while the audio still works.
What it costs in Tomball
Video intercom repair or replacement in Tomball usually lands between $350 and $850, depending on wire condition and how many stations are connected.
How we do it
We check the communication wiring, replace the failed station or cable, re-terminate the connection, and test call and unlock functions before we leave.
What Gate Access Control Costs in Tomball
| Item | Typical range in Tomball |
|---|---|
| Keypad replacement with reprogramming | $180 - $420 |
| Card reader installation or replacement | $250 - $600 |
| Phone entry system repair | $200 - $550 |
Can you add a keypad to my existing gate motor?
Yes, most gate motors in Tomball accept a hardwired keypad even if one was never installed before. The range is $180 to $420 installed, and we’ll confirm wiring compatibility before quoting.
Why does my gate intercom work sometimes but not after heavy rain?
Water is getting into the conduit or a wire splice, and the clay soil around Tomball holds that moisture against the cable for days. We locate the wet splice, re-terminate it, and seal the conduit. Call (346) 296-3138 for a written quote.
Gate Parts & Welding in Tomball
Gate parts and welding in Tomball is where the clay soil and the humidity do their worst work. Hinges rust through at the weld line on ornamental iron gates, posts lean until the latch won’t catch, and bottom rollers on slide gates seize up after years of rain and grit. On ranchette properties off Hardin Store Road, a gate that drags or sags is almost always a structural problem, not a motor problem. Our Gate Parts & Welding service covers the metalwork, the hardware, and the post-setting so the gate hangs true again.
Hinge Replacement
Signs you need it
The gate sags toward the latch side, scrapes the ground, or the hinge pins are visibly worn and wobble when you lift the gate.
What it costs in Tomball
Hinge replacement on a Tomball driveway gate typically runs $120 to $400 per hinge, depending on gate weight and whether field welding is needed.
How we do it
We support the gate, remove the failed hinge, weld or bolt the new one in place, and re-adjust the latch and motor limits before testing the full swing.
Post Replacement
Signs you need it
Posts are visibly leaning, the gate gap changes with the seasons, or cracks run through the concrete footing around the post base.
What it costs in Tomball
Post re-setting in Tomball’s clay soil runs $350 to $900 per post, including new concrete and re-plumbing the gate to match.
How we do it
We pull the old post, drill an oversized footing for the expansive clay, pour new concrete, set the post plumb, and re-hang the gate so it latches clean.
What Gate Parts & Welding Costs in Tomball
| Item | Typical range in Tomball |
|---|---|
| Hinge replacement per hinge | $120 - $400 |
| Post re-setting with new concrete | $350 - $900 per post |
| On-site welding repair | $150 - $500 per repair |
Can you weld my ornamental iron gate back together on site?
Yes, we carry portable welding equipment and can repair cracked pickets, broken hinge stubs, and torn top rails without removing the gate. Most on-site welding repairs run $150 to $500. Call (346) 296-3138 for a written price before we start.
How often do gate posts need re-setting in Tomball?
On acreage properties with heavy clay, we see posts need re-plumbing every 5 to 10 years depending on drainage. If your gate won’t latch after a dry summer, that’s the likeliest cause.
Brands We Service in Tomball
We service Ghost Controls, DoorKing, Elite, and Mighty Mule systems, among others, and we stock common control boards, remote kits, and safety edges locally for faster turnaround. See our brands for the full list. Whatever motor is already on your Tomball gate, we repair it rather than steering you toward a replacement.
Pricing for Gate Repair in Tomball, TX
| Service | Typical range in Tomball |
|---|---|
| Keypad replacement with reprogramming | $180 - $420 |
| Card reader installation or replacement | $250 - $600 |
| Phone entry system repair | $200 - $550 |
| Video intercom repair or replacement | $350 - $850 |
| Hinge replacement per hinge | $120 - $400 |
| Post re-setting with new concrete | $350 - $900 per post |
| On-site welding repair | $150 - $500 per repair |
| Full access control system for one gate | $600 - $2,500 |
Posts in Tomball’s expansive clay run higher than in markets with stable soil because the footing has to be oversized and the post set deep enough to hold through wet-dry cycles. Every price above is the written price you get before any work starts under our Haven Standard, and the number we hand you is the number on the invoice.
Neighborhoods We Serve in Tomball
We work across Tomball, from the older streets near downtown to the master-planned subdivisions along SH 249 and the acreage lots on the city’s edges. Response time for gate repairs within Tomball is typically same-day for emergencies, with scheduled visits for larger structural or installation work.
- Lakewood Grove
- Wildwood at Northpointe
- Tomball Hills
- Saddlebrook Ranch
- Ranch Crest
Service Area - Cities Near Tomball
If you’re on the edge of Tomball or just outside city limits, we also serve Pinehurst, TX, Spring, TX, Conroe, TX, and Humble, TX. Dispatch and scheduling are coordinated from our Houston office, and crews serve Tomball locally.
Serving Tomball, TX - Our Local Coverage Area
We’re based in the Tomball area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Tomball
Most gate repairs and replacements don’t require a permit, but new installations that involve electrical work or changes to driveway access can, depending on the property and any HOA rules. HOA communities along SH 249 often have their own gate design standards. We can tell you what applies to your street when we quote the job.
Yes. A live person answers the phone 24/7, and same-day dispatch is available for emergencies like a gate stuck open, stuck closed, or a motor that won’t respond. Call (346) 296-3138 and we’ll give you a written price before any work starts.
The expansive black clay soil under Tomball swells and shrinks with rain and drought, which pushes posts out of line over time. Properly sized footings and drainage make the difference, and we re-set posts with those conditions in mind. If your gate won’t latch after a dry spell, the posts are the likely cause.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Tomball Customers Say
"Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R."Honest about what did not need doing. Told me the operator had years left and only the control board needed replacing."
- Douglas N."Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B.